The final window was installed last weekend.
These were a pain in the butt.
I had to look back at my own posts to realize how I got them out!
Anyway...
Measure - Measure- Measure
I centered the window to the area and then raised it a bit to avoid a brace on the interior.
Then to the cutting.
i did not bother with the " special" saw blades.
The cutoff wheel was the tool of choice.
One that was complete , I tied off the piece of steel that will be removed so it could be lowered safely to the ground.
I primed the opening and started with the rigging.
Now that is out of the way.
On to raising the window back into the hole.
A generous amount of sealer was applied to the area where the window will be attached.
This was a fun solo task.
All done.
Now for the last patch and onto the sandblasting and primer.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.